📘
Installation manual for DED (V2.0) Panel BMS (V1.0)
Installation:
- Make shure Falcon BMS is installed.
- Install COM port driver for the DED Panel.Go to https://www.silabs.com/developers/usb-to-uart-bridge-vcp-driversDowload and install the driver.
- Connect the DED panel to your computer.
- Go to the device manager of your computer and check if there is a COM port added for your DED Panel.
- Install the DED connector. Go to https://www4.jaheli.nl/index.php/download/ and download the DEDconnector software. Unzip the file to a folder on your computer.
Run the DEDconnector.exe file. - Run Falcon BMS.
- All DED data must be schowing up at the DED panel and FFI oled.
Connection pins at back of DED Panel
FFI oled:
Pin1 – 5V+
Pin2 – GND
Pin3 – SCK
Pin4 – SDA
Indexers AoA and NWS:
Pin5 – Led Disc
Pin6 – Led ArNws
Pin7 – Led Rdy
Pin8 – GND
Pin9 – Led Down
Pin10 – Led Mid
Pin11 – Led Up
Pin12 -- GND
⚠️
Pins for indexers are 5v with 150 ohm resister. Can connected to led. At your own risk!
Pin13 – NC
Pin14 – NC