📘
Installation manual for DED (V2.0) Panel DCS(V1.11)
The DED panel can only be used for DCS combat simulator with F-16C viper.
DCS-Bios has to be installed and running. Some pages at the moment are not correct working. Not all data is generated bij DCS, so DCS-Bios will not show them. This will only be working after updates by DCS and DCS-Bios.
Installation:
- Make shure DCS World and / or DCS World OpenBeta with F-16C viper is installed.
- Install COM port driver for the DED Panel.
Go to https://www.silabs.com/developers/usb-to-uart-bridge-vcp-driversDowload and install the driver. - Connect the DED panel to your computer.
- Go to the device manager of your computer and check if there is a COM port added for your DED Panel.
- Install DCS-Bios. Go to https://dcs-bios.readthedocs.io/en/latest/installation.html and download and install DCS-Bios. Follow the installation manual in the link above. Use the COM port that is showing up in your device manager. Also install the module for the F-16C_50.
- Run DCS world or OpenBeta with F-16C viper
- Run DCS-Bios connected to DCS world.
- All DED data must be schowing up at the DED panel and FFI oled.
Pin Connections at back of DED Panel
FFI oled:
Pin1 – 5V+
Pin2 – GND
Pin3 – SCK
Pin4 – SDA
Indexers AoA and NWS:
Pin5 – Led Disc
Pin6 – Led ArNws
Pin7 – Led Rdy
Pin8 – GND
Pin9 – Led Down
Pin10 – Led Mid.
Pin11 – Led Up
Pin12 - GND
⚠️
Pins for indexers are 5v with 150 ohm resister. Can connected to led. At your own risk!
Pin13 – NC
Pin14 – NC